Danfoss Airflex Dual Passage Rotorseal
Industrial Clutch Parts Ltd. supplies a complete range of Eaton Airflex rotary seals. Available in a variety of sizes and designs. Manufactured in single and dual passage designs.
Airflex dual passage rotor-seals transfer media through two separate passages on the same shaft end. Each passage can be used for a different medium.
- Sizes available: AD, ADP, BD, FDA, RD
- Max. pressure: 150 psi
- Max. speed: 1200 rpm
Eaton Airflex Dual Passage Rotorseal
Eaton Airflex rotor seals permit the transfer of gases or liquids, under pressure or vacuum, into or out of the exposed end of a rotating shaft or body. Rotor joints provide individual control of components mounted on the same shaft, component lubrication, and circulation of fluid systems.
Dual passage rotor-seals transfer media through two separate passages on the same shaft end. Each passage can be used for a different medium. For example, air for clutch actuation and oil for bearing lubrication. Developed in five different designs to meet the needs of many different applications.
1. Dual Passage Rotorseal - AD
- Features a 1/4"-18 inlet port for each of the passages.
- Both passage outlets can discharge directly into the shaft end.
- An optional 1/4"-18 outlet port in the mounting flange could be used for the outer passage.
- The inner passage nose is sealed on its outside diameter by a pair of "O" rings.
- The outer passage is sealed to the shaft end with a compression grommet.
2. Dual Passage Rotorseal - ADP
- Attaches to the shaft end with a 1"-11 1/2 thread outlet instead of a mounting flange.
- The outer passage outlet feeds into the end of the machine shaft.
- The inner passage is a 1/4"-18 port located on a flat of the hex mounting nut.
3. Dual Passage Rotorseal - BD
- Similar to the AD rotorseal, except for a larger diameter mounting flange.
- The inner passage is sealed with a flat rubber washer which compresses on the bottom of a counterbore in the shaft end.
- A compression grommet is used between the shaft end and mounting flange to seal the outer passage.
4. Dual Passage Rotorseal - FDA
- Similar in design to the BD rotorseal with larger passages.
- The two inlet ports and the two flange outlet ports for the outer passage are 1/2"-14.
- Compression grommets are used between the shaft end and mounting flange to seal the inner and outer passages.
5. Dual Passage Rotorseal - RD
- Designed to transmit actuating and cooling fluids.
- Used with mineral oil, water, and air.
- Supported by a non-metallic sealing ring, held against the rotorseal shaft by a light spring force.
